Neutrik

Crimp tool, frame ATTENTION: Suitable dies are DIE-R-* and DIE-R-BNC*

Crimp tool, frame ATTENTION: Suitable dies are DIE-R-* and DIE-R-BNC

Crimp tool die for HX-R-BNC - Shield and jacket: HEX 6,47 mm (A)

Crimp tool die for HX-R-BNC Pin crimping: 1.07 mm Shield and jacket: 6.47 mm (A), 7.36 mm (B)

Crimp tool die for HX-R-BNC - Shield and jacket: HEX crimp 6.47 mm (A), 4.53 mm (B), 4.06 mm (C)

Crimp tool die for HX-R-BNC Pin crimping: 1.60 mm Shield and jacket: HEX crimp 6.47 mm (A), 4.53 mm (B), 4.06 mm (C)

Coax cable stripper for cable O.D. ?8.0 mm

Coax cable stripper for cable O.D. ?8.0 mm for Neutrik rearTWIST BNC NBLC75BVZ17 connector assemblies

The rear compatibility of opticalCON MTP® chassis fitting with standard MTP® (ELITE male)

The rear compatibility of opticalCON MTP® chassis fitting with standard MTP® (ELITE male) breakout cable allows easy adaptation to fiber standard connectors such as LC, SC, ST. The approved dust shutter ensures high mating cycles and minimal maintenance. The housing seal is used for color coding and IP protection. Features & Benefits •Ruggedized and dirt-protected 12-channel fiber optic connection system •For point-to-point multichannel routing •Laser protective metal shutter seals dust proof with two-component rubber gasket •Dust and water resistant according to IP65 in mated condition •Accommodates standard MTP® ELITE male connectors on the rear for simple installation •Rubber sealing gasket (black, blue, green to identify fiber mode)

Crimp tool die for HX-R-BNC - Shield and jacket: HEX 10,0 mm (A)

Crimp tool die for HX-R-BNC

Pin crimping: 1.60 mm
Shield and jacket: HEX crimp 6.47 mm (A), 8.23 mm (B)