TechLogix's ECO Series of fiber optic tools are the perfect compliment to your fiber optic AV or network installation. Occasionally, a component in a kit will need to get replaced or a spare would be nice to have around.
This plunger-style alcohol dispenser bottle is a direct replacement for the bottle that is included in the ECO-TERMK-01 Fiber Optic Termination Kit. Simply flip open the cap, press the top of the plunger with a wipe over the hole, and a small amount of alcohol will start to be released to moisten the wipe. Close the flip-top cap when you're done.
There is no need to worry spilling alcohol all over the work environment when moistening a wipe. There is no need to wonder if the cap was screwed on tight before closing up the Fiber Optic Termination Kit.
The TechLogix ECO-CLEAVER-1 is a professional-grade tool for preparing fiber optic cable for installation and termination. With this cleaver, end of the fiber will be ideal for termination.
The ECO-CLEAVER-1 has ruled lines to make sure your fiber is just the right length, a magnetic lid to keep your fiber secure while cleaving, and a fiber catch bin to keep the glass shards together until you can properly dispose of them.
TechLogix's ECO Series of fiber optic tools are the perfect compliment to your fiber optic AV or network installation. Occasionally, a component in a kit will need to get replaced or a spare would be nice to have around.
These high-quality, lint-free disposable wipes are a necessity when it comes to terminating fiber optic cables. After a few installations of multi-strand fiber optic cable, the box of wipes that came in the ECO-TERMK-01 Fiber Optic Termination Kit will be running low. Now, you can easily get a box of the same wipes that came in the Kit, so you know they'll work well.
The TechLogix TL-3STRIP is a professional-grade tool for preparing fiber optic cable for connector termination. It features three precise holes for use with various types of fiber optic cable, including both multimode and single mode, from virtually any manufacturer.
The largest hole is ideal for stripping the 1.6 - 3mm fiber jacket down to the 600-900 micron buffer. The middle hole is ideal for stripping the 600-900 micron buffer down to the 250 micron coating. The smallest hole is ideal for stripping the 250 micron coating down to the 125 micron glass and/or polymer fiber.
The TL-3STRIP is an essential tool for any fiber installer.
The TechLogix TL-KSHEER is a professional-grade tool for preparing fiber optic cable for installation and termination. The KSHEERs aren't your grade-school scissors... they're designed to cut through the Kevlar and/or aramid yarn strength members found inside fiber optic cabling.
The KSHEERs are super sharp (watch your fingers), super pointy (don't run with them), and super strong (think superman). They're an essential tool for any fiber installer.
Do you have intermittent signal dropouts? Did you accidentally let that patch cable hit the floor while dressing up your equipment rack? How good was that hamburger at lunch?
You might need to clean up the ends of your fiber before you install it into your gear.
The Fiber Optic Pen Cleaner for SC/ST/FC Ferrules is an innovative design of the traditional fiber end-face cleaner. It uses a special dust-free wire material with full contact cleaning ensuring different types of oil and debris will be cleaned with a single click. This pen cleaner can be used to clean SC, ST and FC connectors, including the female fiber ports.